• Ashburton Art Gallery
  • Permeable Pavers
  • Environmentally Friendly Paving Solutions
  • Beautiful paving solutions

Contact Us

38 Anvil Road
Silverdale
Auckland



Postal Address:

P.O. Box 300
Silverdale
Auckland 0944


Phone: 09 426 3030

Mobile: 027 4850 720

 

CONTACT FORM

Full Name(*)
Please type your full name.

E-mail(*)
Invalid email address.

Phone Number(*)
Please enter a phone number

Message
Invalid Input

Are you human?(*)
Are you human?
Invalid Input

  

Products

 

Current range:

 

Colours:

A range of natural colours in riverstone pebble or chip, which may change periodically as new stone colours are obtained. trafficable in 230 x 115 x 50mm pavers in selected colours only

Paver Sizes:

400 x 400 x 50mm (pedestrian only)

230 x 115 x 50mm (trafficable in selected colours)

Other sizes may be available on request

Tolerances:

Pavers are uniform in size, with no shrinkage in the manufacturing process. UV resistant; can be cut with fine-toothed continuous wet saw blade.

Slip resistance:

AS/NZS 3661.1.1993: Slip resistance of pedestrian surfaces. Wet: Greater than 0.4 Confined Compression test: 14mPA, 300mm2 = 49.6 tons to fracture

 

 

 

 

Permeable Paving Base setup

We are happy to provide a no-obligation estimate for the installation of sub base and paving in most areas of New Zealand.

 

A suggested base set up for our permeable pavers to be laid in Non-Trafficable areas: (i.e. no cars driving on them), would be as follows:

  • One layer of A14 geotech cloth
  • Minimum of 100mm of compacted 7/13mm or WAPP12 drainage metal
  • 2nd layer of A14 geotech cloth
  • 25mm of No.2 sand or McCallums EQ3 as bedding layer
  • Permeable pavers 400sq. x 50mm thick
  • No compacting is necessary for 400mm pavers


A suggested base set up for our permeable pavers to be laid in Trafficable areas as follows:

  • One layer of A19 geotech cloth
  • minimum of 150mm of compacted 7/13mm or WAPP12 drainage metal
  • 2nd layer of A19 geotech cloth
  • 25mm of No.2 sand or McCallums EQ3 as bedding layer
  • Permeable pavers 230 x 115 x 50mm
  • Compact bricks lightly with 40-50kg compactor
  • Add no.2 sand blinding over bricks (do not compact paving with sand on the surface)
  • Sweep sand into voids between pavers & sweep off excess
  • Lightly hose off when completed


Further Considerations:

Novacoil under drain should be installed where possible to base to pick up excess soakage
Perimeter of pavers to be locked in
Please note that this specification is subject to ground porosity and bearing strength.

Pavers can be cut using a fine-toothed continuous wet saw blade

 

Storage in Pavers and Base (l/m2):

Based on open graded base material, the following calculations are based on the standard base of 50mm paver, 25mm coarse sand plus 7/11 drainage metal as follows:

100mm drainage metal = 98 (l/m2)

150mm drainage metal = 131 (l/m2)

200mm drainage metal = 163 (l/m2)

 

Paving maintenance and General Care:

 

 

  • Cover pavers with a tarpaulin prior to placing a load of topsoil, sand, bark etc on them to prevent clogging of pavers. 
  • Sweep or power blow off leaves etc should they accumulate over the pavers, to maintain the water flow rate.
  • General power wash every six to twelve months if required to keep pavers clean. In most situations this probably won't be necessary.
  • Pavers can be cleaned using vacuum extraction if necessary.

 

 

 

Disclaimer:

Our company accepts no liability for the consequences of base set up not adequately installed by a third party.

 

Onsite Base Setup photos

 

 

 

 

Permeable Paving application

Permeable Solutionz pavers are trafficable for domestic and light commercial applications such as carparks, driveways, pavements and patios; in fact anywhere that stormwater accumulates and run off is likely to pose a problem. They are also safe and non-slip for cyclists and pedestrians, even when wet.

The pavers are easily laid; bedded in sand and butt jointed. Please refer to the base set up section.

Permeable Solutionz pavers can be laid in any area of urban paving, provided the substrate is sound
(substrate requirements are site-specific).

As a surface may require as little as 30% of Permeable Solutionz paving to be classified as "permeable", it may be used in conjunction with other impervious surfaces.

The pavers exceptionally high levels of porosity, which are generally unaffected by gradient, will slow and dissipate the water captured from surrounding impervious surfaces.

The Permeable Solutionz paving system can be laid around trees and other planted areas to increase water absorption to plant roots.

- Driveways, paths, car park areas, patios, rooftops, pool surrounds, tree surrounds.

Permeable Solutionz pavers are easily maintained and cleaned using low pressure power washing. Frequency depends on areas of use.

lightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightboxlightbox

Download the Permeable Solutionz Brochure (pdf)

 

Download the Permeable Solutionz Paving Guide (pdf)

paving-lay-guide

Download Level Threshold detail here (pdf)

level-threshhold-detail